Search models, users, collections, and posts

Elegoo 250g Small Spool Adapter

Remixed by

Print Profile(1)

All
P1S
X1E
X1
H2C
H2S
H2D Pro
P2S
X1 Carbon
A1
P1P
H2D
X2D
A2L

0.16mm layer, 2 walls, 15% infill
0.16mm layer, 2 walls, 15% infill
Designer
2.3 h
2 plates
4.7(36)

Open in Bambu Studio
Boost
75
232
45
4
557
479
Released 

Description

Content has been automatically translated.
Show original

I modified the Sunlu 250g Small Spool Adapter to make it compatible with my Elegoo 250g spools, which are slightly wider and have a smaller radius

Comment & Rating (45)

(0/1000)

Print Profile
0.16mm layer, 2 walls, 15% infill
perfect for elegoo 250g spools
Show original
2
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
I needed to make the spool adapter a little bit wider to fit better my 4-spool holder mount. Great design!
0
Reply
Don't print in PLA. Even if you think you will remove those before drying, you will forget. Even if you think you'll only use it for PLA spools and never dry, you'll later buy PETG and try to dry it. I also printed in PETG which survived, but It's too flimsy. The pins pop out of the holes. I think adding more thickness is a good idea. Also when printed in PETG it is too loose and can be rotated past the end point. Tightening the tolerances would help
(Edited)
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
works great!
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
It works great. Perfect fit for my elegoo sample set. But it is a bit narrow. Not a big deal to me but it does sometimes tilt enough to pause the AMS if it's not perfectly in there.
1
Reply
yes, mine seem to tilt forward when the filament is being pulling into the AMS. Do you have yours sitting in the grove? Or just resting on the rollers like the normal spool size?
0
Reply
These look great, is there a way to get a simple locking mechanism in place? I don't see any locks present in the model.
The designer has replied
0
Reply
Hello! Both parts of the adapter fit together using a snap-fit located inside the coil. I hope this resolves your query
Show original
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
Top performance
Show original
profile
1
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
good quality print
profile
1
Reply
Boosted
Print Profile
0.16mm layer, 2 walls, 15% infill
Perfect size for 250g spools of the Elegoo brand
(Edited)
Show original
0
Reply
It works perfectly Thanks
Show original
0
Reply