Keyside Insert with plastic boats

Note you MUST use one set of the 3d printed boats in this design to use this insert. The cardboard boats that come with the game will NOT fit in this insert.

Design  uses long and narrow resource trays to replace the included plastic clamshell tray included with the game. 

Uses around 750g of filament as designed.

While not required, the design is set up for using a total of six 6x2 magnets to keep both cottage trays connected on the table.

UPDATED: There are now two different styles of boats in the file - you only need to print ONE of the sets.  The 1x6 setup is easier to remove meeples from but I find the 2x3 more aesthetically pleasing and not too troubling to remove meeples from…so take your pick! 

I also updated the resource trays to put “wells” in them. The resources are much easier to remove now.