The Baby Maker 5000 Starter Kit Massage Headrest

I wanted to have one of these for the longest time and saw them on amazon for well over 100 dollars…well not anymore! This is my first ever print and is made from the ground up so please let me know how it is or any improvements that can be made. I am a little limited on the size that the P1S allows but thankfully the base has zero issue moving while between the mattress. Unless you want to scale this down, this is just the right size for P1S and similar, A1 mini will be too small.

I used 15% infill for everything except the screws, I used 100%. May be a little over cautious but that is what worked for me.

Definitely need supports for the holes so they are as round as possible. Enable supports, tree, angle 30, uncheck remove small overhangs

I have also made this in PETG HF along with PLA, I do not see any differences in strength, but that comes to user preference. 

ENJOY

01/17/26

I have updated the screw to V2. i have lowered the tolerances so it is easier to screw in, I have also removed the supports to make printing faster and made the default 15% instead of the 100%. Feel free to change these settings back if you would like a more robust screw.

03/17/26

I have made a lite version of the base to save on filament per request. Should cut down a lot on filament but it increases the time to print by a lot.

04/02/26

The lite version was taking too long and found it actually used more filament. I have uploaded a new version that uses less filament and the print time is about the same.

04/19/26

I have added an extension for everyone that has an extra thick mattress. The profile comes with one extension and a shorter screw. Print two of these and you are good to go.