Two Trees Bluer strain relief

The Two Trees Bluer strain relief model was created as a response to the potential danger of not having proper strain relief on the bed wires of 3D printers. After watching the Sovol SV06 Plus unboxing stream by Joe Telling, it became clear that negligence in this area can be hazardous. Although some cable guides are available, this model offers a more secure solution by providing holes to fit a few zipties. Stay safe and don't forget to use proper strain relief on your 3D printer.

Tweet about the strain relief on the sovol sv06 plus:

https://twitter.com/joeltelling/status/1628137195860291585

Some models are fanart and are shared as artistic tributes, you may not sell, share, or profit from them. For original designs, a commercial license is required to sell physical prints (available on Maker World or Patreon).