External Thermostatic Parrot Nest | Digital Display Temperature Control Wall Heater | Visible Window | Drawer-Type Bottom Tray for Bedding

It's getting cold, print a warm little home for the birds ^_^

After nearly two weeks of design and 6 revisions, it's finally released! No bolts or glue are needed for installation, the steps are as follows:

1. Material preparation: In addition to all printed parts, you need to cut a 25cm length of filament for the hinge of the flip lid

   Materials to purchase: USB heated reptile thermostat (about 20 yuan on Taobao) Acrylic sheet 125mm (width) x 230mm (length) x 2mm (thickness)

   

2. Fold the heating part of the thermostat, thread it through the oval hole at the back of the house, unfold it and place it in the wall heater groove on the back, then cover it with the wall heater lid
3. After securing the heating element, push the thermostat into its slot from inside the house, and neatly tuck all wires into the adjacent gap
4. Push on the thermostat cover, clip the sensor head into the small notch on the cover, ensuring the sensor head is exposed inside the house
5. Insert the small window and door into the main body of the house, and snap the bottom layer into the perch
6. Assemble the connecting part of the flip lid with the main body, and insert the pre-prepared filament
7. Clip the hook onto the cage wire, align it with the hook slot at the back of the house, and hang the house

8. Place bedding material into the base, and slide it into the slot at the bottom of the house