Search models, users, collections, and posts
Resistor model
IP Report
Print Profile(2)
0.12mm layer, 2 walls, 15% infill
Designer
1.4 h
1 plate
0.12mm layer, 2 walls, 15% infill, Separate Plates
Designer
1.5 h
2 plates
Open in Bambu Studio
Boost
4
18
0
0
10
4
Released
Description
Boost Me (for free)
I want $40 gift card
This is a resistor model i made in Tinkercad. It is a 2 part model so you just need tu connect the parts to get your resistor ready. It prints in less than 2 hours and it is a print by object model so you don't have to waste time in multiple plates.
IMPORTANT NOTE
Please don't scale down this model unless you want to test the tolerances. If tou scale it down, you have a risk that the parts dont fit together.
License
This user content is licensed under a
Creative Commons Attribution
Comment & Rating (0)