AeroScout Motor Mount Extension
Print Profile(1)
Description
This is a motor mount extension for the AeroScout. I printed it with PLA and standard infill, also tried 100% infill. I didn't see a marked difference.
Parts Needed to Complete:
M3 screw 10mm x4
M3 screw 16mmx4
M3 Nylon lock nut x8
M3 flat washers x4
All parts were purchased at Ace Hardware
4 Lock nuts are glued into the mount using medium CA.
10mm screws are used to attach the mount to the plane. (Note: Motor must be mounted BEFORE mounting to the plane)
16mm screws are used to mount the motor to the mount.
You will also need to drill a hole to pass the motor leads into the fuselage. I used a ½" bit.
I have only tested this with a Bad Ass 2315-2300kv motor with a Bad Ass 50A esc. Also used a Master Airscrew 3 blade CCW 6x3.2
https://www.masterairscrew.com/products/3mr-series-3-blade-6x3-2-propeller-ccw-black?rfsn=7903900.50a6f1d&variant=40366977974295
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (1)