Nio ES6 Wireless Charging Pad Spacer for Huawei Phones

The wireless charging pad in my Nio ES6 2024 model usually charges Apple phones. However, when a Huawei phone is placed on it, it either doesn't charge or charges intermittently.

After much research, I found that if the phone is pushed to the very top of the charging area, it charges, but if it slides back, it stops charging.

It seems the charging coil position below was only designed with Apple phones in mind, not Huawei.

Before, I used a lipstick or hand cream to prop it up. But it didn't fit well, so it would still slide away if I wasn't careful.

Moreover, the charging pad tends to tilt downwards, causing the phone to naturally slide down while the car is moving.

With a 3D Printer, I designed this small object. It perfectly props up the phone, preventing it from sliding.

I only have a Nio ES6 2004 model car and a Huawei Mate 6 phone. I cannot guarantee if it's suitable for other Nio models or other Huawei phones.

Please check carefully before printing.