Parametric Jaw Box

Parametric box to store and transport chuck jaws. Box portion may be used as a tray. Models with and without magnets. Magnetic box may also be mounted to wall via the center hole. Those new to this feature, navigate to 

Measurements needed (all  are in mm):

1. Jaws Diameter: Total diameter of jaws when chuck is FULLY closed. See picture.
2. Jaws Height: Bottom to top of jaws. See picture.
3. Label: “JAWS” and "1,4,3,2 are baked into the file. Use slicer paint fill function with edge detection on. Not filling will result in blank box/lid. You can then customize as you desire via the slicer.

Any filament should be fine. .2 mm or .24 layer height with 

If used, magnets are 5x10x60 bar magnets (Amazon).

Print: Any layer height. 3 walls. 20% infill pattern of choice. Any filament, but there I use PETG for impact resistance. TPU would be even better but long print. 

Please rate, like, collect, boost, and share, but do not sell without contacting me here on Maker World. Follow for more models- Joe