Tiki Torch (Real Fire)

I/Designer assume no liability or responsibility for any damage, injury, legal consequences resulting from the use, reproduction or modification of this model

 

  When I saw the torch contest, I immediately thought of fire and what better way to combine fire and 3D Printing than a tiki torch? That's not the only reason I was motivated to make it; another factor was my HATRED of mosquitoes! I mean who could like a mosquito (but really who)? So this model holds a homemade tiki torch made with a 16-ounce wide mouth jar. It doesn't stick into the ground (at least not yet), but sits on a table.). I have found that a 8 ounce jar works well for suffocating the flame 

 

 

Assembly:
 

I'm not really doing anything for this part just slide in the torch Just to be clear BEFORE ITS LIT 

I would suggest printing in PETG I did not print all mine in PETG but I think it is the best bet if you want a lasting one.  I used these jars and if you do not use these I am not sure if it will fit.

I had no part in the creation of the video and am just linking the video I used to make mine. Also I did not use a coupling and it works fine. The video overcomplicates things a bit you really just need to pop a hole in the lid of a jar and then stick a wik through it.