Search models, users, collections, and posts
Dollhouse Christmas Tree Skirt Stand
IP Report
Print Profile(1)
0.2mm layer, 3 walls, 50% infill
Designer
36 min
1 plate
Open in Bambu Studio
Boost
4
4
0
0
0
0
Released
Description
This is a little tree skirt stand to hold up a vintage tree that my wife was using in her dollhouse.
The base of the tree is 75mm wide and the ‘trunk’ of the tree is 2.5mm
It is printed with a 50% fill for the weight with three wall loops and an optagram pattern for the top because it looks like a snowflake.
It is printed in standard PLA.
Finally, the wood trunk is slightly larger than 2.5mm in a few spots so I ran a 2.5mm drill bit through the opening to give a little clearance. This probably isn't generally necessary.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (0)