Sonicare 4100 Travel Case

A perfect way to drop in your Sonicare 4100 and go, no disassembly required, just plop it into the enclosure and go, no need to remove your brush head!  

This was styled similar to another remix of the rugged box but due to size requirements and differences in the brush handles I had to completely re-design it specific to the Sonicare 4100. 

NOTE: This model is only designed to fit the Sonicare 4100 - this is typically a smaller brush size compared to the more premium models of Sonicare brushes. If you have one of the larger/premium brushes, go check out this model which will likely fit better: https://makerworld.com/en/models/728401#profileId-659939  

Also, the latch for this model is different, I had to shorten it so the normal rugged box latch will not fit.  

Finally, for simplicity I've included plastic parts so you shouldn't be required to use the M3x30 screws, if you don't want to - https://www.printables.com/model/514317-rugged-box-printable-pin-screw-replacements 

NOTE/WARNING: the pins and latches plate can be difficult to print, I've done what I can to make them as printable as possible but you may need to adjust if they don't turn out perfectly.  Depending on how your printer is setup you may need to scale down -1% or sand a little bit but in testing, you can usually press them in and work them back and forth to get them to fit/work.  

Looking for this model on Printables?  https://www.printables.com/model/1111782-sonicare-4100-travel-case 

Do you have a Sonicare 4500?  Look no further: https://makerworld.com/en/models/728401-travel-case-for-philips-sonicare