Emergency Bathroom Stall Door Lock Card Kit for broken doors

***PLEASE CLEAN YOUR BED PROPERLY BEFORE PRINTING. DAWN DISH SOAP(Or Equivalent) AND HOT WATER THEN DRY WITH PAPER TOWEL OR AIR DRY!! NOTHING ELSE NEEDED!! THIS WILL ENSURE YOUR PRINT IS SUCCESSFUL***

##  These models printed as shown but if you dont clean your bed properly and have adhesion issues, then you can add a brim or mouse ears. I test all my prints and it is proven to print as I set it up. ##

Great for those emergencies when you have to use a public restroom and find the stall door broken.

Remove parts from card insert cylinder into the base hole(may need firm pressure to seat it) with base piece on outside of door feed post through the gap then slide inner bar piece over the post until snug then you can use the dual hole flat tab to help secure it together if needed sliding it on as neccesary to tighten the grip.

Printed at .20 layers, arachne walls, i have trees (auto) > Trees Hybrid with bed only and remove small overhangs checked.. it may create small trees to help stabilize the cylinder piece, i have had luck with just the tabs holding it in place.

Simple stupid idea i came up with for fun.