Search models, users, collections, and posts
Volvo 1.6D DriveE MAF Adapter For TubeFilters
IP Report
Print Profile(1)
0.16mm layer, 2 walls, 15% infill
Designer
4.8 h
1 plate
Open in Bambu Studio
Boost
10
12
0
0
12
1
Released
Description
Boost Me (for free)
Boost 🚀 if you liked it ❤️ Helps a lot :)
Was made for my car which is a 2012 Volvo S60 Drive-E 1.6D
(Use good glue to assemble)
Requires drilling out the vacuum tube hole after gluing it on. glue the seams from the inside so its vacuum tight)
Was made to fit this enclosed air filter. Other "cold air intakes" are just hot air intakes.
(if link is broken just search for something like: "Cold Air Filter Carbon Fibre Enclosed Intake" on Aliexpress)
DONT print with PLA. its not good for anything that needs durability and heat resistance.
ABS, ABS-CF, ABS-GF, ASA... or Better is highly recommended
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (0)