Search models, users, collections, and posts
Lead Bar Magnets
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
24 min
1 plate
Open in Bambu Studio
Boost
1
2
0
1
0
0
Released
Description
Miniature models of lead 29.0lb lead bars as stackable fridge magnets.
Two bars w/ different stamps.
(1) 29.0lb
(2) 7.3g
Magnets are 8mmx2mm (per seller), but measure out to be more around 8mmx1.75mm.
You'll need five (5) magnets per bar; three (3) at the bottom and two (2) at the top.
There should be two pauses in the print to allow you to embed the magnets, just make sure they're all facing the same way.
I printed in Bambu Gray PETG, did a light sand, and then a quick blackwash.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (0)