DEG1 eGPU Dock Enclosure / Case REMIX - short Back

I remixed Dopins DEG1 enclosure to perfectly fit the DEG1 eGPU dock. The original case was about 37mm too long since it aims to accommodate longer GPUs. Since my RX 6650XT is a short, dual fan model, the Enclosure was longer than it needed to be. 
So I shortened it a bit to perfectly match the DEG1s length.

The profile I attached is for PLA since the heat isn't a problem on smaller, lower power GPUs. My 6650XT uses about 120-150W while gaming and the PLA stays solid. 

If you plan to use a GPU with 200W+ I would recommend testing or straigt up print in PETG-HF or ABS. 

To get the rest of the files please visit Dopins original model (and leave him a like). He did a great job with the enclosure and print profiles!

 

Happy printing!