Search models, users, collections, and posts
Car Jack Wheel (Duralast 3 Ton Low Profile)
IP Report
Print Profile(1)
0.6mm nozzle, 0.3mm layer, 4 walls, 95% infill
Designer
3.3 h
2 plates
Open in Bambu Studio
Boost
2
12
0
0
6
0
Released
Description
The inner part is made with PETG, and is pretty much all walls and no infill, while the outer part is TPU and is 50% infill to allow for some squishing.
Since I wanted a tight fit to avoid using glue or epoxy, I needed to use a rubber mallet to put all the pieces together.
I have to test these at full capacity.
Since this is used with potentially dangerous amounts of weight, use at your own risk.
License
This user content is licensed under a
Creative Commons Attribution
Comment & Rating (0)