Dremel 90° Wall Drill Guide - Pine Makers

The Dremel 90° Wall Drill Guide is a compact and practical accessory designed to help you drill perfectly straight holes at a 90° angle against any wall.
This model is lightweight, portable, and folds apart when not in use.

It is composed of 4 printed parts:

1. Butterfly ends (x2) – convert standard nuts into wing nuts (glued with superglue).
2. Closure part – half-circle piece that clamps onto the Dremel.
3. Main corner base – 90° corner with half-circle, designed to press against a wall for stability.

Two M2x12mm screws (5mm diameter holes, min length 12mm) are required for assembly. Once in place, the accessory holds your Dremel steady, allowing you to move it up and down with one hand while staying perfectly aligned to the wall.

Make a pause when slicing for inserting the screws.

This design is perfect for anyone who needs accurate drilling without a large drill press.

Looking for more convenience? The Dremel Press Desktop Stand improves on this model with a self-standing, desktop-friendly design, smoother motion, and one-finger operation for precise Dremel work. https://makerworld.com/en/models/2084604-dremel-desktop-drill-press-stand-pine-makers

Like this design? Check out more creations and support my work over on Instagram:

https://www.instagram.com/pine_makers?igsh=MTNvaTR5N3IzeTZoNQ==

This 3D model is protected under a proprietary license. By downloading or purchasing this file, you agree to the following terms:

You are granted a non-exclusive, personal, and non-transferable license to use this file for personal 3D printing only.

You may not copy, modify, distribute, sell, or share this model or any derivative works in any form.

Unauthorized redistribution or commercial use is strictly prohibited and may result in legal action.

For commercial use, licensing, or collaboration inquiries, please contact me directly.

Thank you for respecting my work and supporting independent creators!

Print Settings

• Printer type: FDM
• Material used: PLA (recommended: PETG or ABS for more durability)
• Layer height: 0.2 mm
• Supports: Required
• Infill: 5%
• Approx. print time: ~50 minutes
• Parts: 4 (2x butterfly ends, closure, main base)

Assembly & Finishing Instructions

1. Print all 4 parts (Pause mid print for screws inserts).
2. Glue butterfly ends onto standard nuts using superglue.
3. Assemble the closure and main base.
4. Insert Dremel and tighten screws.
5. Press the corner against the wall and drill vertically.

Safety Notes

• Ensure the accessory is firmly assembled before use.
• Always wear safety goggles and protective equipment when drilling.
• Use caution when handling sharp drill bits.
• Do not apply excessive force; let the Dremel do the work.
• Store disassembled when not in use to prevent damage.