Search models, users, collections, and posts
Philips Hue Flux Light Strip 90° Holder
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
53 min
1 plate
Open in Bambu Studio
Boost
28
87
2
1
87
65
Released
Description
Philips Hue Flux Light Strip 90° Holder – for Maximum Indirect Lighting
A minimal, practical 3D-printed holder that lets you mount your Philips Hue Flux Light Strip at a perfect 90° angle to the surface — boosting light output while keeping that clean, indirect glow. Ideal for behind beds or other furniture.
Design & Fit
- Designed specifically for the Philips Hue Flux Light Strip
- Holds the strip by gently clamping it — secure fit, no wobble
- Mounting angle turns the light strip 90° from the mounting surface, increasing illumination efficiency (only lighting upwards)
- Perfect for indirect ambient lighting setups behind beds or cabinets
- Slim, unobtrusive design that disappears behind furniture
Print Settings & Notes
- Material: PLA
- Nozzle: 0.4 mm
- Layer height: 0.2 mm
- Infill: 15%
- Supports: none required (print flat on its side)
Assembly & Mounting
- Attach the holder using strong double-sided tape on the flat back surface
- Press firmly onto your mounting location (wall, bed frame, furniture, etc.)
- Press the Flux Light Strip into the top clamp
- Use multiple holders along the strip for perfect alignment and long-term stability
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (2)