Spotify Car Thing Flush Monitor Mount

Print Orientation:
For best results, print the model on its side. This minimizes the amount of support needed. Supports are optional, but auto-support works well to handle the slight overhangs and can improve surface finish.

Mounting Recommendation:
Use double-sided foam tape for secure attachment. Suggested size:

• 1 inch × 2 inches (25 mm × 50 mm)

Recommended tape: ~$7 for the roll
Scotch-Mount Indoor Double-Sided Mounting Tape, 1 in × 125 in

This is my first model, I am trying to learn the platform as best as I can!
Constructive criticism is always welcome!
I hope you enjoy my simple car thing mount!
 

NOTE:
This was specifically designed for the back center of the KTC 27inch IPS 1440p 300Hz Monitor.
! Adjusting the extrusion length of the mount should allow it to mount fine to any monitor !