ShutUp! PolyDryer - Buzzer Silencer

If you have enough beeping noise from your PolyDryer, spend 11 minutes of your printer time and 30g of TPU to solve it once and for good.

A simple, tight fit, no sticky tape, which eventually falls off, scaring the sh!t out of you at the least expected time. Don't ask me how I know it :)

How to mount:

1. Remove the 4 screws at the bottom of the base.
2. Gently separate the top and bottom housings of the PolyDrye, paying attention to not displace the cables from their grooves.
3. Press the silencer over the buzzer
4. Put the top on the bottom, ensuring that the screen panel snap into the top groove.
5. Screw in all 4 screws
6. Turn the PolyDryer, on and, for the first time in your life, don't jump or twitch your eye :)