Minecraft Logo

Minecraft logo

This model is free - no diamonds required…

Prints in parts on 2 plates. One for the border, another for the letters. This separates the colours for those without an AMS. 

Tight tolerances which allows the pieces to click in and hold for a semi-permanent option.  This is very satisfying when assembling. Use glue to hold the pieces together for a permanent solution. Be careful when pushing the ‘A’ and ‘R’ into the base. These must fit over the central pins to sit correctly.

Modelled from scratch to allow the pieces to overlap by a minimum 3mm.

There are 2 different design profiles available:

• The standard - which is the same scale and thickness as all my other designs. Roughly 30mm font height and specifically modelled to be uniform at 24mm thick. This profile is best for sitting directly on a bench, shelf, desk or table. It is thick which allows it to stand on its own without falling over. Great balance of size and filament. 
• The large - which is scaled to as big as a 256x256 plate will fit. Usually will fit within the plate dimensions by more than 98%. This is the same thickness as the standard profile and is able to stand on its own. This is the best profile overall but the most expensive to print.

Due to the tight tolerances, these prints do not scale well. If you wish for another size that is not available, contact me and i'll see what I can do. You can attempt to resize yourself, although it may not fit together well.

I do not own the trademark or copyright of the original logo that this model is designed off. This is fan art.

If you like this model, check out some of the other signs, logos and magnet designs by ClickKey here: https://makerworld.com/en/collections/21018690-signs-logos-and-magnets 

 You may also like this Minecraft Chicken Fidget Clicker! Get it here: https://makerworld.com/en/models/2577819-minecraft-chicken-fidget-clicker#profileId-2842774