Nikolaus crosier / Mikulášská hůl (berla)

St. Nicholas' stick - an extension for a broom or any pole up to 28 mm in diameter. Can be secured with an M3 screw.

The stick needs to be printed horizontally with supports, or cut off the protruding center and printed separately, then glued. The best option is to cut the spiral lengthwise and print each half separately. The extension needs to be printed vertically with the opening for the broom facing up. There are projects ready for download with the center cut off and with the cut spiral supplemented with pins for precise gluing (2 plates). I recommend 3 perimeters for printing, 10% infill is enough, for strength, print the end of the extension on the maximum number of perimeters, as set in the prepared projects.

The spiral can be attached to the extension using an M3 x 20-30 mmm screw, but it is not necessary, the spiral holds firmly.

If you like the model, please give it a like. ❤

St. Nicholas' stick - an extension for a broom or any pole up to 28 mm in diameter. Can be secured with an M3 screw.

The stick needs to be printed horizontally with supports, or cut off the protruding center and printed separately, then glued. The best option is to cut the spiral lengthwise and print each half separately. The extension needs to be printed vertically with the opening for the broom facing up. There are projects ready for download with the center cut off and with the cut spiral supplemented with pins for precise gluing (2 plates). I recommend 3 perimeters for printing, 10% infill is enough; for strength, print the end of the extension on the maximum number of perimeters, as set in the prepared projects.

The spiral can be attached to the extension using an M3 x 20-30 mmm screw, but it is not necessary, the spiral holds firmly.

If you like the model, please give it a like. ❤