RC28R 3-in-1 Servo Brace Upper Deck

Change logs for Version 2.2:

• Increased length for both sides of the battery holder (to fit smaller sized battery and large battery)
• Added a small stopper for the battery holder arms
• Added a new plate in print profile for additional piece of small battery spacer (to fit Smaller sized battery, Large battery not required)

• Updated photos

   

The 3-in-1 Servo Brace includes the following functions:

• Servo Brace
• Center Damper Post
• Battery Holders

Features:

1. Designed so that the center damper post is supported by the chassis so no flex.
2. Able to fit Large size battery 44.5 x 24 x 12.3mm as well as Small sized battery 44.5 x 20 x 12.3mm
3. Able to fit smaller size battery as well (2 x Flat head M2 x 4mm Screw Required)
4. Increased the center damper post height by 3mm from the original center damper height to fit the battery as well
5. Removed the adjustability of the original servo brace so that no guess work (position will be furthest away from front bulkhead, for comparison to original mounting position)

Requires:

• 4 x Button head M2 x 5mm (2 for center damper post, 2 for battery holders)
• 2 x Flat head M2 x 4mm (for smaller sized battery but why would you?)
• (re-use the screws from the servo brace)

When inserting battery remember to tighten down battery holders for the holders to perform well (do not over tighten!)

(re-print when it can no longer be tighten properly)