AMS 2 Pro Tilt Stand

A tilt stand for the AMS 2 Pro to allow easier access (or in my case because the lid hit my top shelf without the stand) that maintains the AMS shape with a gap in the bottom middle for airflow. The stand prints in 2 main pieces, 2 printed connectors, and 4 small optional TPU anti skid cylinders that can be glued on. I highly suggest using the TPU anti skid pieces or your choice of anti slip material for the bottom or it will slide around.  The TPU prints work great once filament spools are loaded into the AMS.

The stand maintains air intake as well as exhaust for the AMS 2 Pro.  The bottom is open and the rear has a notch for exhaust out.  

I used PLA for the stand and have had no issues due to heat from drying filament. Adjust other filaments accordingly for shrinkage.

Complete model uses roughly 375g of filament with the print profiles. There are 2 print profiles. The H series printers can print Left/Right side of the tilt stand on 1 plate.  X/P/A1 users will need 2 plates to print the two sides. Both profiles have a separate plate for the needed connectors as well as a plate for the optional TPU anti slip parts. 

Assembly is very easy after printing all the parts.

1. Install your choice of anti slip material (printed tpu or other) on the bottom of the 2 main stand parts.
2. Insert the 2 printed connectors until they stop into one side of the printed stand (they are not interchangeable so you won't be able to mix them up).
3. Line up and slide the other half of the stand fully onto the connectors (you can use adhesive if you wish once assembled and in position with the AMS it won't come apart. I am not using adhesive and it hasn't had any issues)
4. Slowly position the AMS 2 Pro onto the stand and reconnect it if you have it disconnected.  

If you run into any issues, reach out to me and I'd be happy to assist.  

If you'd like the matching AMS HT tilt stand it should be uploaded by end of day 12/01.  Ran out of time today.