Dutch Smock Windmill Dutch Mill scale HO 1:87

Dutch Windmill type Bovenkruier scale HO 1:87

This Holländermühle was created in Onshape and is meant as a static display piece.
The Cap can pivot on the Body, just like on a real Smock Windmill. 
If you use it on a model (train) diorama, it may be fun to, once and a while, turn it “into the wind” ;-)
This download comes with 2 build plates, that both can be printed without the need for supports.
HOWEVER, if your bed leveling or adhesion isn't optimal, the tiny Spacers and / or Hub might not stick to your build plate.
If that should be the case: reprint these with a “mouse ear” or “raft” to solve the problem.
It all printed fine on my P2S, (+ several trials) but on a bedslinger it might be a different story…
As mentioned, on the 2nd build plate are 2 Spacers, to move the Sails away form the body, 
this is a very close fit with 1 spacer, and if your sails have any warp, they may touch the body, hence the 2nd spacer.

This windmill has Sails (that are slightly beveled) turning ANTICLOCKWISE, just like the majority of Dutch windmills, please keep this in mind when fitting it to the hub!  This HUB is a VERY TIGHT fit, I suggest using a bit of silicon oil to help it click in the sails, and please, try not to break it…

ATTENTION: this download is for the body and cap (plate 1) and sails, hub and spacers (plate 2) both WITHOUT SUPPORTS,

TO COMPLETE THE MILL YOU NEED THIS DOWNLOAD FOR THE WOODEN BEAMS ! (with supports)

Since I didn't find a way to include one build plate with supports and two without, I have uploaded it a a separate model.
THE SUPPORTS OF IT ARE VERY, VERY, VERY HARD TO REMOVE ! ! ! 
It took me over HALF AN HOUR to do so ! ! !