Mounting bracket for ZBT-2 from Nabu Casa

More mounts for Nabu Casa devices can be found here.

_____________________________________________________________________________________________

Design
Nabu Casa's new Zigbee and thread fidget ZBT-2 adapter unfortunately no longer had a good spot on the shelf without being too close to other antennas. So a wall solution was needed.
I kept the design as compact as possible without sacrificing stability. And while I was at it, a suitable version for the Multiboard System was also created.

Variants
There are two variants each for the wall, IKEA SKADIS, and Multiboard versions.
One variant requires a USB-C male-to-USB-C female adapter with a 90° angle so that the cable can be routed downwards. Alternatively, you can use a cable with a suitable angled connector.
In the other variant, the USB-C cable is routed either to the right or to the left – depending on what best suits your setup.
 

Mounting

• Wall
  The distance between the screw holes in the wall plate is 77 mm.
  The screws I used are M4x20 mm, and the screw heads have a diameter of 7.8 mm.
• Multiboard
  Mounting to the Multiboard wall can be done using this connection: 2x Big Thread Multipoint.
  This ensures the adapter sits securely yet can be easily removed if needed.
• IKEA SKADIS BOARD
  Simply print and hang.

Printing
I used PLA Basic from Bambu Lab – it works really great here.
I set the layer height to 0.1 mm to avoid any issues with the dovetail joint. Additionally, this makes the surface a bit finer and more appealing.
Only the hooks of the IKEA SKADIS BOARD mount  require support structures, but these are very small and easy to remove.

Links

Wood Screws Torx Screws 4x20 *: https://amzn.to/3XqtUk8

Pan Head Screws Torx M4x20mm *: https://amzn.to/3KwF2sQ

USB C Male to C Female USB C 90 Degree Adapter *: https://amzn.to/487S894
USB C Data Cable (90 Degree Angle)*: https://amzn.to/48rg2v5
 
Thanks to @DavidD for the Multiconnect System and Jonathan (KeepMaking) for creating multiboard

Updates:
06.01.2025
- Added IKEA SKADIS BOARD as a mounting method. Thanks to @Leerzeichen  for the suggestion.
- Enlarged rear cutout for the angled USB-C connector. Thanks to @Cosmo q for the hint.
                          

Like this 3D model?

☕ Show your appreciation by buying me a coffee! 

👍 Share my creation and leave a comment below with any feedback or suggestions!

Note

All links with "*" are Amazon affiliate links. You are supporting my work at no extra cost to you.

All devices were purchased and paid for by myself.