Bag hooks for a changing table

„It's an easy-to-print model that also works without support structures. It prints quite quickly but greatly simplifies things if you have a

 baby and no diaper pail.

It is simply placed on the outer raised edge of the changing table (15.5 mm). Before printing, make sure that the outer wall where it is inserted or clamped also has this width. If your changing table is a bit narrower or thicker, just write to me, and I will add a suitable model.

The diaper bag is clamped into the designated hooks. This avoids the annoying opening and closing of the bag when you are in a hurry or the little one is already squirming. :)

I personally printed it in PETG, so I cannot say if it also works with PLA, as some people have a heat lamp at the changing table.

If you have any further questions, feel free to ask them. Otherwise, I wish you a lot of fun with the part and hope that it makes your everyday life a little easier.”