Skadis slanted 5 sectioned Container - Free 3D Print Model

Search models, users, collections, and posts

Likkleidiot

Tools>Organizers

IP Report

Print Profile(1)

All

H2D

H2D Pro

P2S

H2S

H2C

X2D

A2L

0.2mm layer, 4 walls, 15% infill

Designer

7.6 h

1 plate

4.9(16)

Open in Bambu Studio

Boost

271

1029

357

148

Released

Description

This is a streamlined 5-section storage container designed specifically for the IKEA Skådis pegboard system.
The organiser includes:

Four separate compartments at the back for tools, stationery or small parts
One wide compartment at the front for larger items
A sloping profile for better visibility and quick access
2 mm wall thickness for a strong, reliable print

Dimensions: 230 mm (L) × 115 mm (W)
Height: 120 mm at the back, sloping down to 50 mm at the front

Perfect for workshops, craft rooms, electronics benches, or general home organisation.

makeup accessories caddy

tool holder

Comment & Rating (21)

@Manila_Official

Print Profile

0.2mm layer, 4 walls, 15% infill

I printed two parts at once because I have the H2S and everything fit. But there was an issue: near the end of the print, the supports detached and the hooks didn’t form. So now I’m using it as a pencil case instead.

The profile uploader has replied

@Likkleidiot

That's a shame..I think i've had the same issue on 1 or 2 occasions..can't recall if i used tree strong or hybrid in the end

(Edited)

@Manila_Official

Replying to @Likkleidiot :

The support was part of the model itself, not a tree-support attached to the build plate. It detached during printing, so the print didn’t come out properly. I started the print from my phone and didn’t notice it in time. But it’s okay — nothing serious. Here are the photos I attached below. You can see that one of the small mounting tabs printed as two separate pieces — so only one out of the four tabs printed correctly. I’ll try sanding them down so they don’t press against the glass. Other than that, the model is really great. You did a good job.

@MommaRainbow25

Print Profile

0.2mm layer, 4 walls, 15% infill

I absolutely love this!!!! it sucks that it didn't fit all that well on my honeycomb wall as planned but I fixed the issue with just printing a normal strip for it to have a home. I printed it in rainbow translucent PLA and I'm so happy that I did. Also if anybody is curious it works great if you need to use it as a little organizer to keep all your small stuff such as tweezers, tools, etc. I'm personally using it for a little organizer to keep things I normally grab for quite often right next to my bed lol. it's so handy to have and also so incredibly simple that it makes it so perfect for my chaotic ADHD brain lol. This makes brain happy, very happy 🤣