Milo - LED Name Lamp

"MILO" as a printable LED name lamp
 

ATTENTION:
The finished name has been included as an STL file The letters are all already arranged If the print area is large enough, you can pull several letters together onto one plate and print them connectedly Please do not forget to "merge the letters" Be careful not to let the letters slip, otherwise the passages will no longer fit and the geometry of the entire name will be altered
 

Print settings: 0.2mm with 8% infill is sufficient
For the bodies, I would use "seamless" support for the LED passages

Please do not scale down much Otherwise the covers might not fit anymore   
ATTENTION: If it is scaled too small, the passages for the LEDs in the letters will also become smaller (Print a test beforehand) - And do not forget to scale the covers as well 

 

I recommend NOT scaling the X and Y axes smaller than 70-80%

The covers can also be printed mirrored on the X axis This way the covers close flush at the front The disadvantage, however, is that the covers are no longer as easy to remove I recommend printing a mirrored cover as a test beforehand

The letter pairs must be glued together Please ensure that the LED passages are flush with each other A special adhesive for PLA/PETG is best suited for this

For LEDs, I recommend inexpensive 1-5m RGB LED strips for 8-12€ or, even better, COB-LEDs Higher-quality RBGic LEDs also allow for individually controllable letters, depending on your skill

For this name length, it is better to use 5m

If you have any questions, I am happy to help


I am happy to create further individual LED names upon request and with a small donation