Search models, users, collections, and posts
Print Profile(1)
0.2mm layer, 4 walls, 25% infill
Designer
1 h
1 plate
Open in Bambu Studio
Boost
2
4
0
0
2
0
Released
Description
I was building my own 6-inch rack, with models from Mauker and have been chaning a few of them. One of those is this one. I was thinking that a lot of people are going to use this tiny rack as their SmartHome setup, so I put the Home Assistant logo on the blank panel.
I also made the holes for the bolts a bit narrower (5.50mm instead of 6.5mm) so the bolt heads have a bit more room to hold on to the panel if yo do not use washers.
The logo is blue and white and I think the Bambu Lab basic PLA Cyan (10603) is a pretty good match with the HAOS logo.
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (0)