Search models, users, collections, and posts
Holder for 3mm plates
IP Report
Print Profile(1)
0.2mm layer, 4 walls, 15% infill
Designer
41 min
1 plate
Open in Bambu Studio
Boost
1
4
1
0
2
2
Released
Description
Content has been automatically translated.
Since I recently occasionally had the problem of slightly warped plywood sheets and they therefore did not lie completely flat, I came up with something to hold the sheet down during laser cutting. After several attempts, I can say it works very well. The holders are simply clamped under the rails.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (1)