Multiboard Snap Mount Caliper Holder
Remixed by
Copyright Claim
Multiboard Snap Mount Caliper Holder
Remixed by
Boost
9
19
4
Print Profile(1)
0.2mm layer, 3 walls, 15% infill, snug supports
Designer
29 min
1 plate
Open in Bambu Studio
Boost
9
19
4
2
52
29
Released
Description
A remix of the Multiboard Push-Fit Caliper holder to directly use the official multiboard remix snap fitting. I found the push fitting to be too loose for my preferences. By using the snap fitting directly, the caliper holder is solidly locked into place on the board.
Confirmed to fit:
- NEIKO 01407A Electronic Digital Caliper (Amazon US direct link, no commission)
The following settings were used to print this is one piece.
Print orientation:
- Face-up, with critical region supports enabled.
Quality
- Layer Height: 0.2mm
- Wall printing order: Inner/Outer/Inner
Strength
- Wall Loops: 3
- Infill: 15%, Gyroid
- Top Shell: 5 layers, 1mm thickness
Speed
- Outer Wall: 180 mm/s
- Slow Down for Overhangs
Support
- Enabled
- Support Critical Regions Only
Comment & Rating (4)
All
Boosted
Good use of Snug and Don't support bridges on the print profile, This is the first time I came across the Snug setting, works well.
1
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill, snug supports
1
Reply
Boosted
Print Profile
0.2mm layer, 3 walls, 15% infill, snug supports
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill, snug supports
0
Reply
No more
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRemixes (1)
Related Models
© 2024 MakerWorld