Search models, users, collections, and posts
UCTRONICS Pi 5 rack sled
IP Report
Print Profile(1)
0.12mm layer, 2 walls, 15% infill
Designer
3.2 h
1 plate
Open in Bambu Studio
Boost
7
6
0
0
8
2
Released
Description
I made this sled specifically for Raspberry Pi 5's + hat. The original sleds worked with 5's, but there was a slot for an SSD under the Pi preventing a hat from working with them. Printable in the orientation the uploaded 3mf is in, or flat on the bottom. You can use ~M2.5*6-8 screws to fasten the Pi to the sled.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (0)