Parametric 3-way pipe Y or T connector

This model is customisable. Adjust the diameter, angle, length, thickness in parameters. Try it! So much fun to play around and see for yourself.

I rather not to set the limit of each parameters in case anyone would have special ideas but I suggest the range is between 40 to 90 degrees. When smaller the angle, use longer length in the main upper pipe.

Specs

Measurements (in mm)

default

od : 43 + pipe thickness

id : 43

length : 35 + 35mm (upper + lower main pipe)

length : 35mm (branch pipe)

angle of branch : 90 degree (Tee shape)

pipe thickness : 2mm (thicker will be stronger but longer print time)

Notes

This is a solvent-weld style pipe connector. Pipes are designed to be fitted inside the opens of the connector.

To have it water tight, please have a good measurement with tolerance, and if necessary, use glue or caulk.

Support is a must in a pipe connector and the default print profile should have it included and i tested myself.