Tulane Green Wave Coasters

Keep all your tables water rings at bay with your Tulane Green Wave Coasters Coaster.

*Note: White inner line of the hat may be too small to print without a .2 nozzle.  Making it black for the main outline or color of the hat to remove that detail will work just fine

I print all my coasters face down on a textured plate to give a grippier rough surface (Textured PEI sheet), but they could be printed face up if you so choose, would just have a different finishing surface. Coasters are 4mm thick with all colors changes/logos of 1mm for full color effect and no bleed through.

If you're looking for the coaster to not slide around, the base comes with 4 indents for Rubber Feet. I designed them to match these Rubber Feet that I use in all my base and coaster designs and other items I design that I do not want slipping

Filament I used for coasters (feel free to use whatever colors you think match, I love hatchbox and sunlu and they continue to work great with my X1C printer):

Green: Esun Pine Green (only green I had in stock to test, could use a darker green I think)

Baby Blue: Sunlu Light Blue

Black: Hatchbox Black

White: Hatchbox White

If two AMS units, add orange for the bill Orange: Hatchbox Orange

If one AMS system:  I was able to “trick” the AMS system (single system) and used a 5th color.  Did 5 colors in the slicer and made sure the 5th (orange) color printed first.  Then when I sent to the printer, I changed the Orange to the yellow slot.  In the yellow slot, I placed orange filament first.  It printed the Bill first.  As it swapped to the white, I pulled the orange out and placed yellow in.  This then printed the yellow the rest of the time.  It does do a color swap each time from “orange” to white, but it always prints yellow.

Disclosure: This post contains affiliate links. If you make a purchase through these links, I may earn a commission at no extra cost to you. Thank you for your support!

Check out the other NCAA coasters in my NCAA Collections