Pillbox_am_pm ver 5 - Free 3D Print Model

Search models, users, collections, and posts

Remixed by

Timeshifte

Household>Other House Models

IP Report

Print Profile(1)

All

X1 Carbon

P1S

P1P

X1E

H2D

H2D Pro

H2S

P2S

H2C

X2D

A2L

0.2mm layer, 2 walls, 15% infill

Designer

8.6 h

1 plate

4.6(16)

Open in Bambu Studio

Boost

131

378

175

Released

Description

This is a remix of Acheituno's Weekly pill box, he has a great design but I needed a pillbox with both morning and evening sections. It also need to be larger. I added labels for am/pm and a divider to keep the two sections apart. It prints all at once without supports. The pictures and profile were printed with transparent PETG. It printed well with PETG, it should standup better long term than PLA. If you want to print using PLA there is no reason not to, I've got some transparent PLA coming and I will put up the profile one I print the model using PLA.

Comment & Rating (22)

@FamilyPrint_HUN

Print Profile

0.2mm layer, 2 walls, 15% infill

I downsized it in Bambu studio and printed it out with A1 mini. It is perfect. 1 little remark: It would be better if the bottom in the box is not oval just squared. More pills would be fit there.

The profile uploader has replied

@Timeshifte

looks Great !!

@user_3420924189

Print Profile

0.2mm layer, 2 walls, 15% infill

einfach super

@eztbucket

Print Profile

0.2mm layer, 2 walls, 15% infill

9 hours and a lot of filament tossed it the garbage. These hinges don't move and the little doors break off whhen you try to move them.

(Edited)

The profile uploader has replied

@Timeshifte

Sorry you had a bad experience, I print all my designs, I'm out of town but will print it again when I get back.

@user_1142385343

Print Profile

0.2mm layer, 2 walls, 15% infill

great!

@bferneau

Boosted

I’m looking to see if the PLA version of this pill box is finished yet. thanks Bernie

@user_2867917389

Boosted

Print Profile

0.2mm layer, 2 walls, 15% infill

the print turned out well enough mainly had minor cosmetic issues, first layer lettering was a bit stringy, I should have tried to slow the print since I used transparent PETG for the main part. I would suggest in a future revision to move the latch to the outside to correct an issue with getting pills out of the pm slot