Search models, users, collections, and posts
T-Nut for NextWave Shark SD110
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
23 min
1 plate
Open in Bambu Studio
Boost
2
5
0
0
5
3
Released
Description
I needed a hold down bolt specific to the NextWave Shark SD110 that I could use Match fit style clamps. This nut uses a 10-24 flathead screw that are less expensive than the toilet bolts most folks use. I printed it in PLA at 15% infill in the vertical position without supports or brim. My test piece has been holding steadfast for over 24 hours
License
This user content is licensed under a
Creative Commons Attribution-NoDerivatives
Comment & Rating (0)