Dartboard Lighting / Lamp
Print Profile(1)
Bill of Materials
- LED-Streifen x 2: Länge 32cm
- Kabel, 2-Adrig x 1: Nach belieben
- Netzteil x 1: 5V / zB. Handyladeteil
Description
Lighting for Soft Dartboards
This small LED lighting was specially developed for soft dartboards
It is simply inserted into the holes where the darts are usually parked
Important Notes
- Hole spacing: 40 mm
- LED strip: self-adhesive, 10 mm wide
- Cable routing: The cable can be clamped between the small hooks
- If the cable is too thin, it can also be secured with the small printable plates
Printing Tips
- Initially, turning the holders might be a bit stiff because they were printed with support
- After a few uses, it will become easier
- Optionally, the holders can be slightly processed with sandpaper or a utility knife to make turning easier
- If desired, the insert holders can also be printed vertically, in which case the 3 pins will be supported
If you have any further questions, please feel free to ask
💡 Practical, simple solution for atmospheric lighting during soft darts!
Boost Me (for free)
If you like the model, I'd appreciate a boost 🚀
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (0)