Search models, users, collections, and posts
Sunlu S1 Filament Dryer PTFE-Tube with Clip for inside
IP Report
Print Profile(1)
0.2mm layer, 3 walls, 15% infill
Designer
14 min
1 plate
Open in Bambu Studio
Boost
167
434
92
11
713
576
Released
Description
Content has been automatically translated.
Sunlu S1 Filament Dryer PTFE-Tube with Clip for inside
for the Sunlu S2 in my Uploads look
PTFE Tube for Filament, which can move in all directions.
Adapter takes a 4x2 mm PTFE hose.
This is pushed about 5cm inwards and about 10 cm remain outside (but can be changed at will, shorter or longer).
see pictures
Installation :
remove the small PTFE piece and then you can insert the tube with PTFE.
It also doesn't matter whether the filament is pushed through the PTFE tube from the top or the bottom of the roll. Both work very well.
The last picture shows both Sunlu's S1 and S2 filament dryers.
created in Fusion 360
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (92)