Ninja Luxe - WDT Tool and Holder

A practical WDT tool for the Ninja Luxe portafilter machine. It is used to evenly distribute coffee grounds in the portafilter and break up clumps

This remix is based on the model by IteraThor. I adapted the screw holes and chose a new actuation mechanism. The rods on the side allow you to easily circle the tool with one finger, thereby rotating it. For me, it has now become a very quick application with a fluid movement

Additionally, I added a stand for the tool and a holder for the portafilter while using the WDT tool and during tamping

For the tool you will need

- 4 M3x12mm countersunk screws

- 10 acupuncture needles or alternatively 0.35mm nozzle cleaning needles with a total length of at least 65 mm

I used these and cut off a piece of the tip to achieve the total length of 65 mm

For assembly, simply insert the 10 needles into the holes and place the top part on. Do not screw the screws all the way in; stop about half a turn before the end so that the tool can move smoothly

Usage: Place the WDT tool on the funnel and turn it about 10 times to reach all areas. Then tamp as usual

Also check out my other model for the Ninja:

Ninja Funnel Spare Part

I hope you like my model, then feel free to leave a boost and a rating.