Search models, users, collections, and posts
VNM desktop wheel stand
IP Report
Print Profile(1)
0.2mm layer, 3 walls, 20% infill
Designer
9.3 h
5 plates
Open in Bambu Studio
Boost
14
11
9
5
22
6
Released
Bill of Materials
Maker's Supply Kits and Parts
Select all
Description
UPDATE 6 Feb 2026
- Added long and short with upside-down layout
VNM DESKTOP WHEEL STAND
This is a desktop stand for wheels with a VNM QR.
There are two versions: one for 330 mm round wheels and one for GT/formula wheels.
Printing parameters: at least 3 perimeters, 0.2 mm layer height, and 20% cubic infill. You can print in PLA, PETG, ABS, ASA, and carbon-filled variants.
Print orientation is as shown in the photo.
| REQUIRED: 2 socket head M6×35 screws. |  |
ASSEMBLY: Screw the two M6 bolts into the plastic without over-tightening (you might damage the plastic). When the bolts start to resist, tighten gently. If you prefer, before fully tightening the two parts, add a few drops of cyanoacrylate and then finish tightening.
Happy printing!
Documentation (1)
Assembly Guide (1)
Instructions.pdf
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (9)