Hardware design board holder for multiboard

I created a elevated multiboard (multiboard.io) holder for the  hardware design boards published by Alexandre Chapelle (alch.shop).

Printed using PLA with quite a lot of room around the boards so there's no need to scale it. 
Could be a bit tighter but I dont want the boards rubbing against each other.

5% infill. 

Attaches by using 2-4 multipoint LITE small thread. 

Depending on your filament you might want to increase walls from 2 → 3.
Otherwise the infill might shine through. 


This is my first uplolad any feedback is appreciated