4x6" Picture Frame

This is a simple frame for 4x6" sized photos to either hang on the wall or set upright on a table with the included stand peg.  Print off your photos and frame them in a snap! Simply print the long and short parts (the included 3mf fits all the parts of the frame on an A1) and all that you will need otherwise is an 4x6" sheet of acrylic (these will fit from Amazon), 2-4 rubber bands, and some optional (but recommended) 4x6" chipboard or cardstock for backing.  The long and short sides of the frame simply slot together and should stay together with a friction fit.  No glue is necessary though feel free to use it if desired.  Place the acrylic in the frame followed by your photo/paper and then the chipboard/cardstock.  Use the built in pegs in the frame to place rubber bands on the back to hold everything in (see the photo).  There is a built in clawed slot to hang the frame on a nail so you can level the frame as needed.  These frames are lightweight, so you could hang these with command strips without any problem as well.  These frames look great in matte white PLA!  I hope you find these useful!  Happy printing!

Printing suggestsions:

I would suggest using tree/organic supports with the back of the frame printed facing down on the build plate. 

If you like this frame, check out my similar 8.5x11" frame and 8x10" frame!