Anet A8 Plus stock fan duct

This is the stock nozzle for the Anet A8 Plus, it has no improvements, just in case you need it.
I also attach a taller version (6 millimeters), useful if you use a longer throat.
Print lying down, on its side, as seen in the 3D model preview, no supports are needed.
To get a result like the original nozzle, print at a layer height of 0.12 mm. I assume that with 0.2 or 0.24 mm it will also look good, but I have only tested at 0.12 mm and the result is perfect.
An infill between 15% and 25% is fine.