Wemos D1 mini + LED Strip Case - Free 3D Print Model

Search models, users, collections, and posts

Bas van der Ploeg

Hobby & DIY>Electronics

IP Report

GIF

Print Profile(4)

All

X1 Carbon

P1S

P1P

X1E

A1 mini

H2D

H2D Pro

H2S

P2S

H2C

X2D

A2L

0.2mm layer, 2 walls, 15% infill

Designer

19 min

1 plate

4.8(8)

0.2mm layer, 2 walls, 15% infill

19 min

1 plate

4.8(32)

0.2mm layer, 2 walls, 15% infill

17 min

1 plate

5.0(4)

0.2mm layer, 2 walls, 15% infill

22 min

1 plate

Open in Bambu Studio

Boost

224

443

347

Released

Description

No supports needed. Printed in PLA with a 0.16 mm layer hight.

The connector itself is stuck to the board using some nano tape, but some hot glue would do the job too.

Comment & Rating (49)

@marcelnic

Print Profile

0.2mm layer, 2 walls, 15% infill

A bit too little tolerance

The profile uploader has replied

Show original

@Treenity

it don’t seem to be a model problem, but a printer/filament tuning problem

@l.vigier12

Good print. Nice job 👍

@CADSmith

Boosted

Print Profile

0.2mm layer, 2 walls, 15% infill

brilliant

@GiorgioMiglia

Print Profile

0.2mm layer, 2 walls, 15% infill

fit together perfectly

@nclark

Fits perfectly, thanks!

@bri0nac

Print Profile

0.2mm layer, 2 walls, 15% infill

A very nice design that snapped right together. Thanks for sharing!

@tdarringer

Print Profile

0.2mm layer, 2 walls, 15% infill

Already printed a few of these, because I use d1mini pretty much for all my LED projects. Maybe I have the wrong connector, but the pin for opening the connector does not fit inside the housing. So I must cut the pin in order to close the lid properly. Not a big deal, but maybe there could be an option with a little higher housing and maybe a small hole at the top to access the connector with a screw driver for example without the need to open the lid.