Search models, users, collections, and posts
Meraki MR44 / MR46 Ceiling Mount Bracket Adapter
Remixed by
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
31 min
1 plate
Open in Bambu Studio
Boost
1
7
2
0
10
10
Released
Bill of Materials
Bambu Filaments
Select all
Description
I needed adapter for Merki MR46, had to make some adjustments to model from “im.jackharvest”
adjustments are:
- first I had extended whole project 1mm on length
then added extra length on 2 notches (by adding 2 small blocks to existing design) on one side and then also additional block to extend length of other notch on the other side.
Only after those changes adapter was sitting properly and thigh in Meraki, hopefully is same for MR44 but don't have one to test only tested on MR 46
I strongly recommend at least PETG for this.
Use supports as those improved notches stick out from walls and you don't want that to build in air.
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (2)