Search models, users, collections, and posts
Freddy Dummy 13
Remixed by
IP Report
Print Profile(5)
0.12mm layer, 2 walls, 15% infill (full AMS)
Designer
41.4 h
9 plates
A1 Mini
Designer
43.7 h
11 plates
No AMS
Designer
7.7 h
4 plates
A1 Mini No AMS
Designer
8.7 h
7 plates
Click to see more
Open in Bambu Studio
Boost
2188
4220
560
137
5 k
1.9 k
Released
Description
This is my remix of a poseable Freddy figure I found on MakerWorld. It uses the Dummy 13 frame mostly. There are a few frame pieces that needed to be customized in order to fit everything together properly. The print profile is AMS, but you can still print in a single color if you don't have AMS. The model pictured was printed using all Bambu PLA Basic. I recommend using PETG for the frame pieces, because PLA will wear out pretty quickly with heavy play. The upper and lower legs are a little tight. You just need to gently pound them in with a hammer. Be mindful when removing the supports from the shoulder. If not carefully handled, it could break pretty easily.
Here's the assembly video:
Documentation (1)
Assembly Guide (1)
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (560)