Search models, users, collections, and posts
Govee Elite Light Track System
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
20 h
5 plates
Open in Bambu Studio
Boost
31
96
7
7
104
43
Released
Bill of Materials
List other parts
- Hillman #8 x 1-in Phillips -Drive Standard Sheet Metal Screws x 200: https://www.lowes.com/pd/Hillman-8-x-1-in-Phillips-Drive-Sheet-Metal-Screws-75-Count/3010125
Description
The first Govee Elite Light Track System that is full printable, and able to be installed after your light system is already up.
It uses puck mounts, with a track system that was intended to be able to be printed on almost any 3d printer regardless of size. Each track piece is 6.5" long.
For a standard 100' Govee Kit you will need to print approximately the following:
(72) Puck Mounts
(140) Channel Tracks
(65) Channel Splices
(2) End Caps (Left and Right)
(4) Connector Covers
Corner Splices are optional depending on your installation.
These are the screws I used for my installation: https://www.lowes.com/pd/Hillman-8-x-1-in-Phillips-Drive-Sheet-Metal-Screws-75-Count/3010125
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (7)