nanoleaf exagonal 2025 no welding

I print them with 15% infill, without support or bed adhesion. It takes about 2 hours for the body and 1 hour for the covers. The covers lock into place. There is a small edge to rest on when they are locked. To hold them together I used a few drops of super glue and some hot glue. The LEDs are just RGB strips with remote control included. You can glue the LED strips with glue or adhesive. I threaded them from a low point to let the cable out and ran them all along the inside before coming back and permanently gluing them. I also used hot glue in some spots to help them stay in place. To mount them I used two screws and simply fixed them. Alternatively, you can drill and insert magnets. I used Bambulab PLA Basic filament

I'm leaving you the link to the other model: https://makerworld.com/en/models/2032452-nanoleaf-project-3d-print#profileId-2191972